Tailings sand making equipment manufacturer

Tailings are “waste” discharged by mining companies under certain technical and economic conditions, but at the same time they are potential secondary resources. When technical and economic conditions permit, they can be effectively developed again.

What equipment is needed to make sand from tailings

The waste rock chips from different sources have different lithologies, different mining and crushing processes, and have very different physical properties. At present, there is insufficient systematic research on the performance of rock chips, and the law of the quality of rock chips and their impact on concrete performance is mastered. insufficient.

The low-quality stone chips have large powder content, rough surface, sharp edges and corners, difficult mud removal and shaping technology, and large investment; the problem of mud removal and shaping is not solved, and it is not conducive to the convenience of concrete, increasing the amount of cement, poor market acceptance.

For different types of waste rock chips, targeted sand making process is required, and the performance of the manufactured sand is also different. Therefore, there are higher management and monitoring requirements for the production of sand and the use of machined sand. Enterprises at this stage I still don’t understand this, and I just want to apply it in a simple way. As a result, the expected economic and environmental benefits are not realized, and the enterprise loses its motivation and determination to practice.

tailings making sand process

Comments

Maintenance and storage method of vibrating screen motor and common troubleshooting

The service life of the vibration motor determines the operating life of the entire screen. Therefore, in the normal production, we must always pay attention to whether the working state of the vibrating screen equipment is normal, whether the vibrating motor is in good working condition, timely check and solve some small abnormalities and faults, and do a good job of cleaning and maintenance, because this can greatly increase the vibration screening. Machine and vibration motor life. dewatering screens supplier Maintenance storage precautions during vibrating screen motor operation The equipment can not be completely dust-free, but also has a harsh environment and dusty conditions. The vibration motor is airless and heat-cooled. It relies on natural cooling, so it must be specially maintained. The following is the maintenance content. 1. It is necessary to pay attention to whether the vibration is abnormal during the use process; 2. Always check if the bolts used in the m...

Fine sand recovery system reduce the sand waste in sand wash

The fine sand recovery system consist of screw sand washing machine , vibrating screen , cyclone. The vibrating Screen was combined with cyclones. Ordinary sand wheel washer or screw sand washing machine can’t process fine sand below 3mm, we researched vibrating screen with cyclone machine. sand recycling system The cyclone is a separation and classification device. When the two-phase mixture to be separated is tangentially introduced into the cyclone from a periphery of the cyclone at a certain pressure, a strong three-dimensional elliptical strong rotational shear turbulent motion is generated. Lzzg's dewatering screen https://www.lzzgmachine.com and sand recovery machine have excellent performance. Compared with Yunnan's local ordinary vibration dewatering screen, the sand washing machine output is twice as high, which greatly improves the production efficiency of the whole line.

300t per hr chalcopyrite washing equipment

Chalcopyrite is a copper-iron sulfide mineral. It often contains trace amounts of gold and silver. Crystals are relatively rare and are tetrahedral-shaped, mostly irregular granular and dense massive aggregates, as well as kidney-shaped and grape-shaped aggregates. Copper yellow, often dark yellow or mottled. The streaks are black with a greenish tint. Chalcopyrite is a relatively common copper mineral, which can be formed in different environments, but it is mainly the product of hydrothermal action and contact metasomatism, and it can often form deposits of a certain scale. The origin is all over the world. In industry, it is the main raw material for copper smelting. In the field of gemology, it is rarely used alone, occasionally as a substitute for pyrite. In addition, it often participates in the composition of some colored stones, inkstones and jade. The high-efficiency spiral chalcopyrite washing machine is mainly used in the washing, grading, impurity removal, and the washing o...

sunset

Search This Blog