lowcost sand washing waste water treatment system

Low-cost sand washing production wastewater and sludge treatment project overview:

The sand washing wastewater is 300m3 / d and the sludge is 30m3 / d.

The main production of construction water washing sand primary products.

A water-washing sand production line with a daily production capacity of 150 tons will crush, screen, and wash nearby sandstone, silica, etc. to produce construction water-washing sand products.

The main environmental pollution problem in the production process of the project is the sludge wastewater and domestic sewage generated by washing sandstone and silica rock. According to the requirements of relevant laws and regulations, sand and stone washing wastewater and domestic sewage must be discharged or recycled after treatment, and the washing sludge should be properly disposed of. The tailings can be exported as good paving gravel.

Total wastewater: about 300 m3 / d of washing production wastewater. The main pollutants are characterized by a large amount of soil and silt in sandstone and silica. After crushing and washing with water, soil and fine sand are contained in the water. The content of suspended matter and colloid is high, and the color is high. The surrounding environment causes pollution. The washing wastewater undergoes the initial sedimentation, coagulation sedimentation, and then is used as sand field washing water for recycling or discharged up to standard. The sedimented sludge is pressed and dewatered by a filter press and then landfilled. The wastewater is recycled after sedimentation treatment. The recycling rate is designed according to 90%, and the evaporation and water loss are supplemented according to 10%. The domestic sewage is treated by septic tanks and used as water for plant greening and nearby agricultural land.

Comments

Maintenance and storage method of vibrating screen motor and common troubleshooting

The service life of the vibration motor determines the operating life of the entire screen. Therefore, in the normal production, we must always pay attention to whether the working state of the vibrating screen equipment is normal, whether the vibrating motor is in good working condition, timely check and solve some small abnormalities and faults, and do a good job of cleaning and maintenance, because this can greatly increase the vibration screening. Machine and vibration motor life. dewatering screens supplier Maintenance storage precautions during vibrating screen motor operation The equipment can not be completely dust-free, but also has a harsh environment and dusty conditions. The vibration motor is airless and heat-cooled. It relies on natural cooling, so it must be specially maintained. The following is the maintenance content. 1. It is necessary to pay attention to whether the vibration is abnormal during the use process; 2. Always check if the bolts used in the m...

Fine sand recovery system reduce the sand waste in sand wash

The fine sand recovery system consist of screw sand washing machine , vibrating screen , cyclone. The vibrating Screen was combined with cyclones. Ordinary sand wheel washer or screw sand washing machine can’t process fine sand below 3mm, we researched vibrating screen with cyclone machine. sand recycling system The cyclone is a separation and classification device. When the two-phase mixture to be separated is tangentially introduced into the cyclone from a periphery of the cyclone at a certain pressure, a strong three-dimensional elliptical strong rotational shear turbulent motion is generated. Lzzg's dewatering screen https://www.lzzgmachine.com and sand recovery machine have excellent performance. Compared with Yunnan's local ordinary vibration dewatering screen, the sand washing machine output is twice as high, which greatly improves the production efficiency of the whole line.

300t per hr chalcopyrite washing equipment

Chalcopyrite is a copper-iron sulfide mineral. It often contains trace amounts of gold and silver. Crystals are relatively rare and are tetrahedral-shaped, mostly irregular granular and dense massive aggregates, as well as kidney-shaped and grape-shaped aggregates. Copper yellow, often dark yellow or mottled. The streaks are black with a greenish tint. Chalcopyrite is a relatively common copper mineral, which can be formed in different environments, but it is mainly the product of hydrothermal action and contact metasomatism, and it can often form deposits of a certain scale. The origin is all over the world. In industry, it is the main raw material for copper smelting. In the field of gemology, it is rarely used alone, occasionally as a substitute for pyrite. In addition, it often participates in the composition of some colored stones, inkstones and jade. The high-efficiency spiral chalcopyrite washing machine is mainly used in the washing, grading, impurity removal, and the washing o...

sunset

Search This Blog